Redmond RMC-M4510 Bedienungsanweisung Seite 21

Reheat
REDMOND RMC-М4510 can reheat cold dishes. To reheat a dish:
1. Fill the bowl with food and position it inside the multicooker.
2. Close the lid and plug in the appliance.
3. Press and hold "Отмена/Разогрев" button. The indicators will light up solid. The timer
will start direct countdown of the reheating time.
The appliance will reheat food up to 70-75°С and will keep it warm during 12 hours. "Reheat"
function can be disabled by pressing and holding "Отмена/Разогрев" button, until the indicators
go out.
The "Keep Warm" and "Reheat" functions enable the appliance to maintain the temperature of
a dish for 12 hours, however it is not recommended to keep a meal warm for more than 2-3
hours, because this may affect its flavour.
"MASTERCHEF LITE"
Discover more possibilities for culinary creativity with the new "MASTERCHEF LITE" function!
While "МУЛЬТИПОВАР" allows setting a programme parameters before it starts, then
"MASTERCHEF LITE" allows adjustments during the cooking process. You can always adjust
any programme, so that it corresponds to you wishes. Does your soup boil over? Does your
oatmeal "escape"? Are your vegetables steamed for too long? Adjust the cooking temperature
or time, without interrupting a cooking programme as if you cook on the stove or in the oven.
You can use "MASTERCHEF LITE" only during cooking. "MASTERCHEF LITE" is not applicable for
"ЭКСПРЕСС", "Time Delay" and waiting to access operating parameters.
When using "MASTERCHEF LITE" the temperature can be adjusted between 35 and 170°С with
1°C increments. Possible cooking time range on the selected programme with 1 minute
increments.
"MASTERCHEF LITE" can be very useful especially when you cook meals on complex recipes,
requiring combination of different cooking programmes (e.g. cooking cabbage rolls, beef
stroganoff, soup and different types of pasta, jam, etc.).
To adjust cooking temperature:
1. Press "Меню" button during cooking. The temperature value indicator will be flashing.
2. Set the desired temperature. To increase the value press "Час/+" button, to reduce the
value press "Мин/–" button. Press and hold the corresponding button down to scroll
through the digits.
3. After the maximum (minimum) value is reached the adjustment starts again. Do not press
the buttons on the control panel for 5 seconds. Settings will be saved automatically.
For overheat protection when setting the cooking temperature higher than 130°С the maximum
programme operating time is limited to two hours (except for "ВЫПЕЧКА"). Cooking temperature
adjustment is not applicable for "ЙОГУРТ" programme.
To adjust cooking time:
1. Press "Меню" button twice during cooking. Time value indicator will be flashing.
2. Set the desired cooking time. To increase the value with 1 hour increments press "Час/+"
button, to increase the value with 1 minute increments press "Мин/–" button. The hour value
changes irrespective of the minute value. After the maximum value is reached the adjustment
starts again. Press and hold the corresponding button to scroll through the digits.
3. Do not press the buttons on the control panel for 5 seconds. Settings will be saved
automatically.
When setting cooking time value to 00:00, the programme operation will be stopped.
Standard Operating Procedure for Automatic Programmes
IMPORTANT! If you use the device to boil water (for example, when cooking foods), DO NOT set
the cooking temperature above 100°C. It can cause overheating and failure. For the same
reason, DO NOT use the programs "FRY/DEEP FRY", "BREAD" and "BAKE" to boil water.
1. Prepare (measure) the ingredients.
2. Fill the multicooker bowl with ingredients according to the cooking programme and
position it inside the appliance. Ensure that all ingredients are evenly spread below the
maximum fill mark on the inside of the bowl. Ensure that it has full contact with the
heating element.
3. Close the main lid until it clicks into place. Plug in the appliance.
4. Use "Меню" button to resume from standby mode. Use "Час/+" and "Мин/–" buttons to
select a programme (the corresponding programme indicator will be flashing). Press
"Меню" button again to confirm the programme selection.
"МУЛЬТИПОВАР" enables to set the desired cooking temperature. Use "Час/+" button to increase
the default value, "Мин/–" button to reduce the value. Press "Меню" button to finish the
temperature setting.
ATTENTION! If you cook at high temperatures with much oil, always keep the lid open.
5. Use "Час/+" and "Мин/–" buttons to adjust default cooking time.
6. Set time of delay if necessary.
"Time Delay" function is not applicable for "ЖАРКА", "МАКАРОНЫ" and "ЭКСПРЕСС" programmes.
7. Press "Старт" button to begin cooking. "Старт" and "Отмена/Разогрев" indicators will light
up solid. Depending on the selected programme, the timer will begin countdown after
pressing "Старт" button or upon reaching the required temperature in the bowl.
"Keep Warm" function can be disabled in advance by pressing "Старт" button. The "Отмена/
Разогрев" indicator will go out. Press "Старт" button again to enable this function. "Keep
Warm" is not applicable for "ЙОГУРТ" and "ЭКСПРЕСС" programmes.
8. An audible signal will be produced to indicate that cooking is complete, the End indicator
will light up on the display. Depending on the selected programme or current settings
RMC-M4510
GBR
21