Gastroback SLOW JUICER ADVANCED VITAL Bedienungsanleitung Seite 71

CAUTION
– Ensure that the juice collector is not filled above the upper rim
of the separating mesh to avoid overflow. Always immediately unplug the appli-
ance, when liquids run onto the motor base and/or run out below the juice colle-
ctor. Clean and dry the appliance, when liquids have been spilled on the motor
base (see: 'Care and Cleaning').
NOTE
If the usage of the pusher is required, press your food down slowly and evenly,
but do not apply too much pressure to get the optimum amount of juices. When
pressing too hard, the pulp will be very wet and there will be only little juice. Addi-
tionally, the juicing system may get clogged easily.
During operation, ensure to avoid overfilling the containers for juice and pulp.
Check, whether the juices are running and pulp is produced. The pulp must fall easi-
ly and without obstacles into the pulp container (see: 'Methods for Removing Obsta-
cles' and 'Solving Problems').
NOTE
When extracting juicy types of fruit and vegetables, you may repeatedly operate
the juicer in forward and reverse operation for a while for getting the optimum
amount of juice (see: 'Using Reverse Operation').
IMPORTANT - Before toggling to reverse operation and back, always switch to
the off position ("O") to make the motor stop completely. If reverse operation does
not work for getting the juicing system free of obstacles, you need to disassemble
the juicing system (see: 'Care and Cleaning / Disassembling the Juicing System').
However, do not attempt to remove the squeezing auger, while the juicing sys-
tem is placed on the motor base. Otherwise, liquids could run onto the motor base.
6. When the motor stalks or runs unusually slowly during juicing, try reverse operati-
on intermediately via the lower position of the power switch ("R"; see: 'Methods
for Removing Obstacles').
7. For juicing larger amounts of food, make breaks of approx. 30 minutes after eve-
ry 15 minutes of continuous operation. During your breaks, switch off the motor
(power switch to the central position "O"), and unplug the appliance. You may
use the breaks for preparing the next portion.
8. After juicing, switch the power switch to "O", and unplug the appliance. Remo-
ve the juicing system from the motor base (see: 'Care and Cleaning / Disassem-
bling the Juicing System').
EN
71