Gewiss Chorus Easy GW 10 763 Bedienungsanleitung Seite 61

INSTALLATION INSTRUCTIONS
When creating the above listed functions, it is not necessary to select a base unit function
as the link is created automatically.
If the "slave" channel is combined with the 4-channel contact interface (GW 90 834) the
following functions are proposed on the base unit.
Names of the functions on the Easy base unit
edges
scene
heating mode
Refer to the Easy base unit documentation for further information on the programming
procedures.
Note. The Cd1, Cd2 and Cd3 channels must only be used
when a thermostat is used to control the fan coil.
SLA (Slave)
• the thermostat operation type and mode with other
KNX/EIB devices from a remote position.
Examples of devices which can be used are the EIB
EASY GSM remote control unit, the EASY control panel
and display, the EASY 4-channel contact interface etc;
• the OFF mode on the thermostat, with priority over all
the other commands, if an open window signal is
received. When the closed window signal is received,
the thermostat returns to its previous operation mode
or to the last mode it was in when it received the
forced OFF command;
• memorising the scenes, max 8: the thermostat
memorises the current operation type, mode and set-
point.
The channel is indicated as "ClimSlave X.1" on the
base unit.
Edge management command (for window contacts)
Scenario management command
Thermal regulation commands (mode)
61
E
N
G
L
I
S
H