Gewiss Chorus Easy GW 10 763 Bedienungsanleitung Seite 41

It is possible to set the following parameters:
According to the operation type, it is now possible to sequentially modify:
Heating
P01 - Set Point
heat
P02 - Set Point
heat
P03 - Set Point
heat
P04 - Set Point T
heat
P05 - Control logic
P06 - Cycle time
P07 - PWM regulation
differential value
P08 - ON/OFF regulation
differential value
P09 - Control mode
P10 - Enable remote control
To scroll the sequence, confirming the values displayed on the screen, press the
until you reach the parameter you want to change.
Press the SET key again to exit the parameter setting procedure or it will exit
automatically after a 30" time-out.
It is necessary to perform both sequences to set the heating and air-conditioning
parameters (in the second sequence it is possible to confirm the parameters which are
the same, and just change the specific ones).
USER INSTRUCTIONS
Operation type (heating/air conditioning)
Day of the week
Minutes
Temperature unit of measurement
FROSTPROTECT
Hour
Air conditioning
P01 - Set Point
cond
P02 - Set Point
cond
P03 - Set Point
cond
P04 - Set Point T
cond
P05 - Control logic
P06 - Cycle time
P07 - PWM regulation
differential value
P08 - ON/OFF regulation
differential value
P09 - Control mode
P10 - Enable remote control
41
HIGH TEMPERATURE PROTECTION
key
E
N
G
L
I
S
H