Safety Precautions - Pelikan Daniel RAY R-20B Bedienungsanleitung

after starting, then the next start will be as normal start.
Note: Once the Governor Mode is enabled, the ESC's Brake and Low Voltage Cutoff Type
settings will automatically be reset to No Brake and Reduce Power respectively regardless
of previous settings.
8. Motor Rotation: Reverse
In most cases motor rotation is usually reversed by swapping two of the three motor wires.
However, if the motor cables have been directly soldered to the ESC cables, motor rotation
can be reversed on the ESC.
9. Switching Frequency : 8kHz/16kHz
8 kHz – Sets ESC switching frequency, 8 kHz works best with most of motors.
16 kHz – Sets ESC switching frequency. Although 16kHz is slightly more efficient, the de-
fault setup is 8kHz due to the higher RF interference caused at 16kHz.
10. Low Voltage Cutoff Type: Reduce Power / Hard Cut-off
Reduce Power – ESC reduces motor power when the preset Low Voltage Protection
Threshold value is reached.
Hard Cut-off – ESC instantly cuts motor power off when the preset Low Voltage Protection
Threshold value is reached
PROGRAMMING THE RAY ESC WITH YOUR TRANSMITTER
Entering the programming mode
1. Switch your Transmitter ON and set the throttle to its maximum position.
2. Connect the battery pack to the ESC.
3. Wait until you hear two short beeps (**) confirming that the ESC has now entered the
throttle calibration mode.
4. If the throttle stick is left in the maximum position beyond 5 seconds, the ESC will enter
the programming mode. Now the programming sequence begins from one function and
its associated setting options to another. (Please refer to the table below to cross reference
the functions with the audible tones).
5. When the tone for the desired function and setting option is reached, move the throttle
stick down to its minimum position. ESC will emit two beeps (**) confirming the new set-
ting has been stored.
6. The ESC only allows the setting of one function at a time. Therefore should you require
making changes to other function, disconnect the battery pack and wait 5 seconds to re-
connect the battery and repeat the above steps.
USING THE RAY PROGRAMMING CARD (OPTIONAL)
You can also use the optional RAY programming card to program your desired function.
The use of the RAY card is very simple and convenient: the programmable function and
their values are to be set with a couple of jumpers. Simply set all the jumpers on the card to
the positions corresponding to the desired values and connect it to the ESC. Programming
your ESC with the RAY Card is a breeze!

SAFETY PRECAUTIONS

- Do not install the propeller (fixed wing) or drive pinion (helicopter) on the motor when you test the
ESC and motor for the first time to verify the correct settings on your radio. Only install your pro-
peller (plane) or pinion (heli) after you have confirmed that the settings on your radio is correct.
- Never use ruptured or punctured battery cells.
- Never use battery packs that are known to overheat.