Pelikan Daniel RAY R-20B Bedienungsanleitung Seite 2

RAY ESC Wiring Diagram
Battery
Please bear in mind improper polarity or short circuit will damage the ESC therefore it is
your responsibility to double check all plugs for proper polarity, and proper connection
BEFORE connecting the battery pack for the first time.
POWERING UP FOR THE FIRST TIME & THE AUTOMATIC THROTTLE CALIBRATION
The RAY ESC features Automatic Throttle Calibration to ensure the smoothest throttle re-
sponse and resolution throughout the entire throttle range of your transmitter. This step
has to be performed just once to allow the ESC to "learn and memorize" your the throttle
output signal of your transmitter. It only needs to be repeated if you changed your trans-
mitter.
1. Switch your Transmitter ON and set the throttle stick to its maximum position.
2. Connect the battery pack to the ESC. Wait for about 2 seconds, the motor will emit two
short beeps (**), then put the throttle in the minimum position, the motor will beep twice
again (**), which indicates that your ESC has recognized the signal range of the throttle of
your transmitter. Then the ESC will perform the test of your battery and will announce the
value of the Brake function - refer to the following chapter.
The throttle has been calibrated now and your ESC is ready for operation.
NORMAL ESC START-UP PROCEDURE
1. Switch your Transmitter ON and set the throttle stick to its minimum position.
2. Connect the battery pack to the ESC.
3. When the ESC is first powered up, it emits two sets of audible tones in succession indicat-
ing its working status.
- The first set of tones denotes the number of cells in the LiPo pack connected to the ESC.
(Two beeps (**) indicate 2 cell LiPo pack while 3 beeps (***) indicate 3 cell LiPo pack).
- The second set of tones denotes Brake status (one beep (*) for Brake "ON" and two beeps
(**) for Brake "OFF").
The ESC is ready for use now.
PROGRAMMABLE FUNCTIONS OF THE RAY ESC
1. Brake: ON/OFF
ON - Sets the propeller to the brake position when the throttle stick is at the minimum posi-
tion (Recommended for folding props).
OFF - Sets the propeller to freewheel when the throttle stick is at the minimum position.
2.Battery type: LiPo or NiCd/NiMh
NiCd/NiMh – Sets Low Voltage protection threshold for NiCd/NiMh cells.
LiPo – Sets Low voltage protection threshold for LiPo cells and automatically detects the
number of cells within the pack.
Note: Selecting the NiCd/NiMh option for the battery type, triggers the ESC to automati-
cally set the cutoff threshold to the factory default of 65%. The cutoff threshold can then
black
ESC
red
Motor
To receiver,
throttle channel