Pelikan Daniel RAY R-20B Bedienungsanleitung Seite 5

Programming Mode Audible Tones
(during the first 4 sec) ** ** ** **
_ * _ * _ * _ *
~~ ~~ ~~ ~~
*_ _* *_ _* *_ _* *_ _*
*_ _ _* *_ _ _* *_ _ _* *_ _ _*
*_ _ _ _* *_ _ _ _* *_ _ _ _* *_ _ _ _*
––– ––– ––– –––
VVV VVV VVV VVV
_*_ _*_ _*_ _*_
_**_ _**_ _**_ _**_
_***_ _***_ _***_ _***_
- Never short circuit battery or motor terminals.
- Always use proper insulation material for cable insulation.
- Always use proper cable connectors.
- Do not exceed the number of cells or servos specified for the ESC.
- Wrong battery polarity will damage the ESC and void the warranty.
- Install the ESC in a suitable location with adequate ventilation for cooling. This ESC has a built-in
over temperature cutoff protection feature that will immediately cut power to the motor once the
ESC temperature exceeds the 230° F/ 110° C temperature limit.
- Use only batteries that are supported by the ESC and ensure the correct polarity before connect-
ing.
- Switch your transmitter ON first and ensure the throttle stick is in the minimum position before
connecting the battery pack.
Throttle Calibration
~ ~ ~ ~
3. PCO - Low Voltage Cutoff Threshold
4. Restore Factory Default Setup
— — — —
– – – –
–– –– –– ––
6. Soft Acceleration Start up
VV VV VV VV
V V V V
W W W W
9. Switching Frequency
// // // //
\\ \\ \\ \\
10. Low Voltage Cutoff Type
_ˉ_ˉ_ˉ_ˉ
ˉ_ ˉ_ ˉ_ ˉ_
1. Brake
2. Battery Type
5. Timing
7. Governor Mode
RPM control off - for fixed wing aircraft
8. Motor Rotation
ESC Function
Brake On /Off
NiCd/NiMH
Li-poly
Low 2.8V/50%
Medium 3.0V/60%
High 3.2V/65%
Restore default settings
Automatic (7-30°)
Low (7-22°)
High (22-30°)
Very soft
Soft
Linear
Heli, range 1
heli, range 2
Clockwise/Counterclockwise
8kHz
16kHz
Reduce Power
Hard Cut Off