JVC KD-DB95BT Bedienungsanleitung Seite 22

Symptom
"NOT SUPPORT" appears and
track skips.
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible
or connected device cannot be
detected.
• Reattach the device.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reload the disc or reattach the USB device.
The iPod/iPhone does not turn on • Check the connection between this unit and iPod/
or does not work.
• Detach and reset the iPod/iPhone using hard reset.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to
• Delete pairing information from both the unit and the
"PAIRING FULL" appears.
"PLEASE WAIT" appears.
"BT DEVICE NOT FOUND"
appears.
Echo or noise occurs. • Adjust the microphone unit's position. ( 11)
• Check the [ECHO CANCEL] setting. ( 13)
20
Remedy
Check whether the track is a playable format.
( 18)
with this unit and ensure the files are in supported
formats. ( 18)
iPhone.
both the unit and Bluetooth device.
Bluetooth device, then perform pairing again. ( 12)
The number of registered devices has reached its limit.
Retry after deleting an unnecessary device.
( 15, DELETE PAIR)
The unit is preparing to use the Bluetooth function. If
the message does not disappear, turn off and turn on
the unit, then connect the device again.
The unit failed to search for the registered Bluetooth
devices during [AUTO CNNCT]. Turn on Bluetooth
from your device and connect manually. ( 15)
Symptom
Phone sound quality is poor.
"NOT SUPPORT" appears.
"ERROR" appears.
The unit does not respond
when you try to copy the
phonebook to the unit.
Sound is being interrupted or
skipped during playback of a
Bluetooth audio player.
The connected Bluetooth
audio player cannot be
controlled.
"H/W ERROR" appears.
"BT ERROR PLS UPDATE"
appears.
If you still have troubles, reset the unit. ( 3)
TROUBLESHOOTING
Remedy
• Reduce the distance between the unit and the
Bluetooth device.
• Move the car to a place where you can get a better
signal reception.
The connected phone does not support Voice
Recognition feature.
Try the operation again. If "ERROR" appears again,
check if the device supports the function you have
tried.
You may have tried to copy the same entries (as
stored) to the unit. Press DISP or G T/P to exit.
• Reduce the distance between the unit and the
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect
again.
• Other Bluetooth devices might be trying to connect
to the unit.
• Check whether the connected Bluetooth audio
player supports Audio/Video Remote Control Profile
(AVRCP). (Refer to the instructions of your audio
player.)
• Disconnect and connect the Bluetooth player again.
Reset the unit and try the operation again. If "H/W
ERROR" appears again, consult your nearest service
center.
Update the Bluetooth firmware. ( 4)