Manual Preset; Tuning Into A Preset Station - JVC kd-sh99r Bedienungsanleitung

Manual preset

You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
FM 1
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to the
memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
10
1 Press SOURCE
repeatedly to select FM
as the source.
2 If necessary, press and
hold M/B (mode/band) for
more than 1 second
repeatedly to select FM1.
Each time you press and
hold the button, the FM
band changes as follows:
FM 2 FM 3
Press ¢
to tune
into stations of higher
frequencies.
4 to tune
Press
into stations of lower
frequencies.
"P1" flashes for a while.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on page 9.
1
Select the band (FM1 – 3, AM).
1 Press SOURCE
2 If necessary, press M/B
FM 1
2
Select the number (1 – 6) for the preset
station you want.
If the sound quality decreases and the
stereo effect is lost while listening to
an FM station...
In some areas, adjacent stations may interfere
with each other. If such interference occurs,
this unit can automatically reduce the
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound quality
and to lose the stereo effect, rather than to
eliminate the interference noise, see "To
change the FM tuner selectivity – IF FILTER"
on page 33.
repeatedly to select FM or
AM as the source.
(mode/band) for more
than 1 second
repeatedly to select the
FM band number. Each
time you press and hold
the button, the FM band
changes as follows:
FM 2 FM 3