Part Replacement Instructions - Simogas ESTIVALE PRIMA series Bedienungsanleitung

When releasing the axial pressure of the control tap, after some 15 seconds the burner pilot light goes out:
•
The thermocouple is defective; it should be replaced according to that explained in the installation book, thus requi-
ring the services of authorized personnel.

7. PART REPLACEMENT INSTRUCTIONS

INJECTOR
If the injector is blocked, remove the injector holder and replace it with another one with the same characteristics. Once the
proper injector is obtained, continue as follows:
For the replacement of the burner injectors, they should be accessed through the upper part of the equipment. Remove the
cooking grill and directly access them.
Once they are accessible, proceed with the replacement by removing the bolts holding them.
BURNER
It is recommended that burner replacement be performed by a quality technician and the distributor be notified.
THERMOCOUPLE
Remove the griddle by unscrewing the four nuts that hold it. Once this is completed, the procedure to follow to change the
thermocouple is as follows:
1. Remove the washer using the appropriate tool.
2. Unscrew the bolt.
3. Remove the thermocouple and the thermocouple hose.
4. Once the thermocouple hose is cut to a length similar to the old one, place the new assembly in the position of the old one.
5. Tighten the bolt.
Replace the washer making it line up with the hole of the thermocouple.
The manufacturer holds no responsibility for modifications not in accordance with the original equipment. The
manufacturer holds no responsibility for malfunctions due to incorrect use of the equipment. The manufacture holds
no responsibility for the functioning and quality of the equipment if these INSTRUCTIONS fOR USE have obviously
In the case of any conflict between the content of each version, the Spanish language version shall prevail.
WARNING
been ignored.
33
EN