Accessories (Optional); Changing The Dust Bag - Dirt Devil Handy Zip Bedienungsanleitung

4 Accessories (optional)

Changing the dust bag

3.4 Changing the dust bag
Change the dust bag at the latest when
this dust bag is full or when it is losing suction
power.
WARNING:
Before you change the dust bag switch off
the appliance and pull out the plug. This will
prevent the appliance
unexpectedly.
1. Open the zip closure (Fig. 1/2).
NOTE:
Be careful and work slowly when removing
the dust bag so that no dust is squeezed out
of the dust bag.
2. Pull the dust bag
back. Hold the opening facing up so that
no dust falls out.
3. Remove any dust found in the dust bag.
NOTE:
You can dispose of the dust bag with the
normal domestic waste as long as it does
not contain any dirt not permitted for
domestic waste.
4. Push the new dust bag onto the
connection piece (Fig. 3/2). Make sure
that the dust bag is pushed on up to the
stop point (Fig. 4).
5. Close the zip closure.
14
from starting
(Fig. 3/1) out of the
4 Accessories (optional)
The optional accessories set (Fig. 2) means
the hand-held vacuum cleaner can be used in
many different ways. Order number
8, „Spare parts".
4.1 Assembling the suction hose
WARNING:
Switch off the hand-held vacuum cleaner
and pull out the plug before assembling or
removing the accessory. This will help avoid
accidents.
You can assemble the suction hose in two
variants.
A. Assemble direction onto the cap
(higher suction performance)
Assembly:
1. Open the sealing cap (Fig. 5/2) by lifting it
with a screw driver (Fig. 5/1). Remove the
belt (Fig. 8/1) with your forefinger or the
belt lifter (Fig. 2/4, optional) from the shaft
(Fig. 8/2).
2. Insert the suction hose (Fig. 5/3) into the
opening up to the stop point. It clicks
audibly into place.
Removing:
1. Press the release button (Fig. 5/4) and
remove the suction hose.
2. Lift the belt with your forefinger or the belt
lifter (Fig. 2/4, optional) onto the shaft. The
belt must run as shown in (Fig. 10) for the
shaft to turn the correct way.
NOTE:
If assembled incorrectly, the belt will
automatically jump off the shaft. If this
happens, put it on the shaft the other way
round.
3. Close the cap (Fig. 1/5).
chapter