Attaching A 4:3/16:9 Selector Board To The Camera Head; Selecting The Gain Of 36 Db - Sony OHB-T450WSP Installationsanleitung

Setting Up the CCD Unit
Attaching a 4:3/16:9 Selector
Board to the Camera Head
A 4:3/16:9 conversion function can be used by
attaching the 4:3/16:9 selector board supplied with the
OHB-T450WS/T450WSP to the camera head.
1
Loosen four screws on the left side of the camera
and remove the left side panel.
Loosen these
four screws.
2
Unscrew the two screws on the center board and
remove the board.
Loosen these two screws.
10(E)
3
Attach the supplied board in place of the center
board and secure it with the three screws.
Tighten these three screws.
4
Reattach the side panel to the camera head and
tighten the four screws.

Selecting the Gain of 36 dB

Normaly the gain is selected from –3dB to +30 dB by
setting the GAIN switch on the BVP-550/550P to L, M
or H. When the OHB-T450WS/T450WSP is attached
to the BVP-550/550P, the gain of 36 dB can be
selected using the setup menu on the BVP-550/550P.
For details, refer to the maintenance manual supplied with
the BVP-550/550P.
MENU: System Config
PAGE: Others2
W Gain: Off ÷ On