Coffee Grinder - Vigan KR1 Bedienungsanleitung

SPEEDS
3 - 4: liquids and lighter food.
5 - 6: stiffer solid foods. Dry foods, eg. nuts, do not blend them for longer than 1 minute continuously.
P:
ice crushing, blending using pulses.
• After you are done blending, turn the switch to position 0 and unplug the appliance.
• Remove the container, remove the lid and pour out the blended food. Be careful not to touch with
your hands or tools blade. Risk of injury or damage to the tool.

COFFEE GRINDER

Coffee grinder is used in the same way as a container for mixing. The difference is in a smaller amount
of material you grind. The grinder can be used not only for coffee, but also, for example nuts and dried
fruits. Assembly and use in done the same way as with the blender above, only the container lid has
no hole for filling.
USE OF MINCER
• Disconnect any connected attachement from Shaft, disconnect stainless steel bowl and mixing
bowl. Then put on the blender motor its cover.
• Cut the meat into pieces of about 2 cm. Remove all bones and tendons.
• Depending on the desired mincing choose the appropriate disc.
• Do not reach inside the mincer, there is a risk of injury!
• Do not use the mincer continuously for more than 4 minutes. After this time, allow the device to
cool for 5 minutes.
• Before you get exercise in filling sausages, we recommend to stop the device after each filled
sausage.
• Adapters for meat and pasta are all stored on the stuffing tool.
ASSEMBLY
• Put drive auger to the grinder. Put blade on the shaft the way the blade directs to the disc.
Make sure the blade is properly inserted to the profile of the square-shaped shaft.
• Put the selected wheel for grinding (4, 6 and 9 mm) on the shaft.
Projections on the disc must fit into recesses on the blade.
• Screw the socket in and tighten carefully.
CONNECTION
• Remove the drive cover on a mincer by turning it clockwise and lift it.
• Turn the meat grinder clockwise and put it on the drive shaft. When it clicks in, turn it
counterclockwise, so that it is perpendicular.
• Connect the filling part.
USE
• Before you connect the appliance ti the socket, check that the switch is in position 0.
Only now can the appliance be connected to the socket.
• Prepare a container for minced meat. Put it under the output of the grinder.
• Put the meat into a filling part and push it deeper using the stuffing tool.
29
str