Turning Off - Vigan KR1 Bedienungsanleitung

TURNING OFF

• When you've finished mixing, turn the switch to 0. Then disconnect the unit from the wall socket.
• Press the lever to lift up the arm.
• Remove the attachment connected (twist and pull).
• Turn left the lid on the dish and remove it.
• Turn the bowl in opposite direction, than arrow indicates and remove it from the stand.
• After removing the mixed food, clean all unclean parts.
BLENDER USE
• Use only one function of food processor at the time. For example, do not use blender and kneading
in the bowl at the same time. Disconnect the adapter from the motor shaft and a knife for meat
grinder and a put on cover of the meat grinder.
• When using a blender, do not move the arm unit.
• To the mixing container put less than 0.2 liter, and more than 1.5 liters of liquid.
• Blender starts only when the container is properly fastened.
BLENDER CONTAINER ASSEMBLY
• Put glass container with plastic base upside down on a flat surface.
• Put silicone sealing ring into the base.
• Put in a mixing blade.
• Attach the blade using plastic ring by moving counterclockwise.
• Container and a plastic base can be cleaned in the dishwasher, wash other parts by the hand.
BLENDER CONTAINER ATTACHMENT
• Remove engine cover by turning it to left and then pulling up.
• Take the handle of the container and put it to the base so that the
of a unlocked lock.
• Turn the container to left so that mark
• Fill the container with the food that you want to blend.
• Carefully put the lid on the container. The tab must close the opening.
• Attach the cover for adding the ingredients and turn it clockwise.
USE
• Minimum load of container is 0.2 liters, maximum is 1.5 liters. Follow this limit.
• In the event you are blending hot liquids or foods that foam, do not fill the container more than at 1 liter mark.
• Only use a blender with container containing food or drink, not with an empty container or even without it.
• Before you turn on the blender, always put on the container lid and cover with the hole for filling.
• When you are adding food, use either the designated hole or turn the blender off.
Do not open the lid while the blender is turned on.
• Cut the food for blending into smaller pieces and put them into the container.
• Put the lid on the container and the cover of the hole for filling.
• Check that the main switch is on the position 0.
• Plug the power cord into the power socket.
• According to the requirements turn on the speed of 1 to 6.
• Do not blend continuously for more than 4 minutes! If food is not after all this time properly
blended, turn off the blender and let it cool for about five minutes. You can continue after that.
28
str
is at the symbol of a closed lock.
symbol is at the symbol