ASSEMBLY OF THE REAR DRAWBAR
(Fig. 4)
- Position drawbar 3 in correspondence
with the central hole, then lock it with
the screw and the self-locking nut. The
drawbar can be adjusted in height.
- Unloosen screw 4, adjust and screw
back on (Fig. 4).
ASSEMBLY OF THE HANDLEBARS
Fig. 4
(Figs 5/A-5/B)
Fit handlebar 1 onto the Motorhoe by
means of the relative screws and
washers as shown in Fig. 5/a.
The handlebar may be adjusted in hei-
ght in three positions by unscrewing lock
knob 2 and positioning the screw in
another hole after having turned the han-
dlebar. Thereafter lock the knob.
On request, the handlebars can be adju-
sted both in height and sideways with
Fig. 5/A
the possibility of locking them in the
wanted position.
For those models having such an adju-
stment, this operation must be carried
forth with lever 3 (Fig. 5/b).
Make sure that lever 3 is always locked
after adjustment.
ASSEMBLY OF THE LEVERS
Fig. 5/B
(Fig. 5/C)
The forward and reverse throttle cables
(if applicable) are already connected to
the frame and fitted in their correspon-
dent levers.
Fit the levers in their respective seats
on the handlebars.
How to change the drive
(forward-reverse):
Fig. 5/C
- Pull control lever 4: forward gear
- Pull control lever 5: reverse gear (Fig.
5/C).
21