Pioneer PDA-5003 Bedienungsanleitung Seite 87

4 Use the 2/3 and 5/∞ buttons to select the
desired value.
÷ When the [POSITION] item is selected, the 2/3
buttons control movement in the Horizontal
direction (H), and the 5/∞ buttons control
movement in the Vertical direction (V).
P O S I T I O N
H
+ 8 8
SET SET
÷ Use the 2/3 buttons for the adjustments of
[CLOCK] and [PHASE].
C L O C K
SET SET
Notes
÷ Make these adjustments for each input (INPUT1 or INPUT5)
and signals.
÷ If INPUT2 is selected, only the [POSITION] can be adjusted.
5
Press the SET button.
Pressing the SET button writes the value into the
memory and returns the display to the step 3 screen.
6
When adjustment is finished, press the MENU
button to exit the menu screen.
[SCREEN] mode adjustment items
Below are brief descriptions of the options that can be set
in the [SCREEN] mode.
POSITION
H ················ Adjust the picture's position to the left or
right.
V ················· Adjust the picture's position upward or
downward.
CLOCK ········· Adjust letter breakup or noise on the
screen. This setting adjusts the display's
internal clock signal frequency that
corresponds to the input video signal.
PHASE ·········· Adjust so that there is minimum flicker of
Notes
÷ The [CLOCK] and [PHASE] adjustment items are supported
÷ When the [CLOCK] frequency is changed, the [POSITION]
÷ If the adjustment items in the [SCREEN] mode are adjusted
V
÷ When the [AUTO SETUP MODE] set to [ACTIVE], selecting the
+ 8 8
MENU EXIT
To reset [SCREEN] mode settings to the default
If settings have been adjusted excessively or the picture
on the screen no longer appears natural, it may prove
more beneficial to reset the [SCREEN] mode to default
settings instead of trying to make adjustments under
already adjusted conditions.
1
0
:
MENU EXIT
2
PICTURE/SCREEN Adjustment
screen letters or color misalignment. This
setting adjusts the phase of the internal
clock signal adjusted by the [CLOCK]
setting.
only for INPUT1 and INPUT5.
command's horizontal [H] option may require readjustment.
excessively, the picture may not be displayed properly.
[POSITION] and [CLOCK] adjust modes will cause a message
to be displayed on the screen, but adjustment is possible.
However, if the input source is changed, the adjustment value
stored in memory will be the one automatically set with the
auto setup mode. If you wish to record a manually set
adjustment value, set the [AUTO SETUP MODE] to [INACTIVE]
(pages 29 to 30) before beginning your adjustments.
In step 3 in the previous procedure, use the 5/∞
buttons to select [SCREEN RESET], then press the
SET button.
S C R E E N R E S E T ?
Y E S
SET SET
Use the 2/3 buttons to select [YES], and press
the SET button.
All [SCREEN] mode settings are returned to the
factory set default.
N O
MENU EXIT
31
En