Adjusting Screen Position, Clock, And Phase - Pioneer PDA-5003 Bedienungsanleitung

Adjusting screen POSITION, CLOCK,
and PHASE <automatic adjust>
By pressing the remote control unit's AUTO SET UP
button or by selecting [AUTO SETUP MODE] from the
menu, the unit will automatically set the screen position
and clock to best match the current image input.
When the button is pressed, the optimum
settings are automatically selected for the
current input source.
Press the remote control unit's AUTO SET UP button.
AUTO SET UP
Notes
÷ This setting is supported only when a computer signal is
connected to INPUT1 or INPUT5.
÷ Perform this adjustment individually for each input function
(INPUT1 or INPUT5), and each signal type.
÷ Optimum settings may not be possible for low-luminance and
certain other signals. In such cases, set the [AUTO SETUP
MODE] to [INACTIVE], and use the manual adjustment
methods explained in the following section, "Adjusting
screen POSITION, CLOCK, and PHASE <manual adjust>".
When the automatic setup mode is
selected, the unit will automatically be
adjusted to the optimum image settings
whenever the power is turned on, the input
source is changed, or the type of input
signal is changed.
AUTO
SET UP
1
2
PICTURE/SCREEN Adjustment
Remote control unit
DISPLAY INPUT SCREEN SIZE
STANDBY/ON MENU
/ SET
MENU SET
Display operating panel
Press the MENU button to display the menu
screen.
MENU
PICTURE SCREEN
C O N T R A S T
B R I G H T N E S S
C O L O R
T I N T
S H A R P N E S S
P I C T U R E R E S E T
SET ENTER
Use the 2/3 buttons to select [OPTION].
MENU
PICTURE SCREEN
L A N G U A G E
E N E R G Y S AV E
T I M E R S E T T I N G
S C R E E N M G T.
A U T O S E T U P M O D E
A U T O F U N C T I O N
P I P D E T E C T
S P L I T F R E E Z E
SET
ENTER
MENU
2/3
SET
5/∞
– VOL +
5/∞ 2/3
INPUT1
SETUP OPTION
: 0
0
:
: 0
: 0
0
:
MENU EXIT
INPUT1
SETUP OPTION
: E N G L I S H
: S TA N D A R D
: I N A C T I V E
: O F F
: A C T I V E
: O F F
MENU
EXIT
29
En