Specifications; Ec Declaration Of Conformity - Makita GA7020 Bedienungsanleitung

ENGLISH
1-1. Shaft lock
2-1. Switch trigger
2-2. Lock lever
4-1. Wheel guard
4-2. Screw
4-3. Bearing box
5-1. Lock nut
5-2. Depressed center wheel
5-3. Super flange

SPECIFICATIONS

Depressed center wheel diameter
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
Explanation of general view
5-4. Inner flange
6-1. Lock nut
6-2. Depressed center wheel
6-3. Inner flange
7-1. Lock nut wrench
7-2. Shaft lock
8-1. Lock nut
8-2. Outer flange 78
8-3. Cut-off wheel
Model
Spindle thread
-1
)
Overall length
Net weight
Safety class
equipment
environmentally compatible
GA7020/GA7020F/GA7020S/GA7020SF
END202-2
without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.27 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
For European countries only
Noise and Vibration
and its
The typical A-weighted noise levels are
sound pressure level: 90 dB (A)
sound power level: 103 dB (A)
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
ENE048-1
EN50144.
EC-DECLARATION OF CONFORMITY
Model;
ENF002-1
GA7020,GA7020F,GA7020S,GA7020SF,GA9020,GA9
020F,GA9020S,GA9020SF
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN50144, EN55014, EN61000 in accordance with
3
8-4. Inner flange 78
8-5. Dust collecting wheel guard
10-1. Exhaust vent
10-2. Inhalation vent
11-1. Commutator
11-2. Insulating tip
11-3. Carbon brush
12-1. Brush holder cap
12-2. Screwdriver
GA9020/GA9020F/GA9020S/GA9020SF
180 mm
M14
8,500
473 mm
4.7 kg
/II
Wear ear protection.
2
.
230 mm
M14
6,600
473 mm
4.7 kg
ENF100-1
ENG021-1
ENH001-6