CAUTION
Possible damage to the cable!
►
To avoid damage, observe the position of the cables when sliding the
device into the bay. There is a fi re hazard if cables are damaged!
♦
Carefully push the device into the installation bracket
place.
♦
After all the connections have been established, press the RESET
for about 6 seconds with a ballpoint pen or other sharp object.
♦
Attach the face plate as described under "Installing the face plate".
Removing the device
To remove the installed device, proceed as follows:
♦
Insert the right and left keys
device. Ensure that the elevations on the spanners are facing outwards
(The tabs are now bent back).
♦
Pull the device out.
SAR 28 A1
into their respective slots on the sides of the
31
until it locks into
30
button
22
67
GB
MT