Tempco RF Bedienungsanleitung Seite 36

e) When the configuration between One Zone and Main zone
programmer RF is finished (few seconds), the following
screen must appear and the One zone should exit the "rF
init" mode.
If you have other One zone in your installation, repeat the steps
"a)" to "d)".
RF Installation – On/Off
Your main zone programmer can manage up to 4 On/Off receivers.
You will have the possibility to create a weekly program to switch
On and Off the equipment connected to your receiver.
To use a receiver (Wall, Flush or Plug version) as an On/Off type,
you must link it alone with the main zone programmer.
No thermostat must be linked previously with the receiver.
Then use the same rules described in the One zone part to link it
with your Central.
RF Installation – External contact
If your installation use more than one unit of regulating zone
(Master, One zone...), you can use the External contact to
st
1 Page
nd
2 page
36