Installation - Regulation Type - Tempco RF Bedienungsanleitung

Ambient sensor calibration:
- To check the temperature in the room, put a thermometer at 1.5M
distance to the floor in the concerned room and wait 1 hour to be
sure that the thermometer show the correct temperature.
Then you can enter the value saw on the thermometer with the
arrow buttons (Up) or (Down), valid or cancel your adjustment with
the corresponding button.
- When a calibration is made the cancel button appears.
- To erase the calibration already made press on the cancel button.
Floor (Ext) sensor calibration:
- The calibration must be done as described above if the external
sensor is connected and used like a deported ambiance sensor.
- If the external sensor is used as floor sensor, the thermometer
should be put on the floor.
Installation – Regulation type
3.10.3
In this submenu you must choose the type of regulation which
must be used for the room managed by the programmer.
To change the sensor, press on the desired option to frame in
green the button.
On / Off: (Hysteresis)
Basic regulation with static differential of 0.5°C
PWM1: (proportional band)
30