Thermostat Submenu (For Main Zone Only) - Tempco RF Bedienungsanleitung

3.1 Thermostat submenu (For main zone only)

On this submenu you can see and adjust the settings temperature
for the main zone (zone managed by this unit).
Comfort setting
Change the set point for Comfort temperature by using the arrows
buttons (Up) or (Down).
This setting is also used in "Auto" mode.
Valid or cancel your adjustment with the corresponding button.
Reduced setting
Change the set point for Reduced temperature by using the arrows
buttons (Up) or (Down).
This setting is also used in "Auto" mode.
Humidity level
(Only available with humidity sensor connected)
The Humidity level is used only in cooling mode to prevent the
house of floor condensation.
If humidity is detected the system will stop the cooling function in
the house and start up the humidity drier connected to the RF H&C
Master.
The activation of this function will be showed on main screen by:
- A yellow information logo
- A blinking Cooling logo.
.
14
One short
press to
adjust the
set point.