Working Mode - Tempco RF Bedienungsanleitung

b) Cooling Function
Use this function if you don't need cooling function on the selected
zone.
Example: Cooling function should be deactivated for room with
residual humidity, like Bathroom, kitchen...
c) ITCS Function
The Intelligent Temperature Control System will activate your
installation in advance to assure the desired temperature at the
hour programmed following your weekly program.
This automatic control system works in the following way:
When you start your thermostat for the first time, it will measure the
time taken by your installation to reach the set temperature. The
thermostat will re-measure this time at each program change to
compensate external temperature change & influence. You can
now program your thermostat without the need to adjust the
temperature in advance because your thermostat does it
automatically for you.
Press on the "ITCS" button to highlight it to active.
The maximum time of the ITCS anticipation will be 2 Hours.
It will be better to disable the ITCS function when you have small
step duration in the programme.
You can see the start-up of this by a green Flag
screen.
3.3.2

Working mode

You can only change the settings of the zone managed by this unit.
Some working mode like "Timer" is only available for the zone
managed by this unit.
You can control the working mode of the other zones only if the
thermostat is set on "
Manual Comfort mode,
In this mode the set point will be followed all the time.
You will have the possibility to change the set point temperature on
this unit by using the arrows buttons (Up) or (Down).
" clock mode .
16
on the zone