MAXDATA 700T Benutzerhandbuch Seite 126

Model 400M & 700T User's Manual
Suspend-To-RAM
There are three ways to enter Suspend-To-RAM mode:
•
Press the Hot Keys <Fn> <F4>.
•
Allow the system to invoke this action, by setting the Auto Suspend Time Out,
and setting the Suspend Mode to Suspend(-To-RAM) in Chapter 11.6.
•
With Suspend Mode set to Suspend(-To-RAM) in Chapter 11.6, flip down the
LCD panel.
When in this mode, electrical power is removed from the LCD display panel. Only
content of the RAM is maintained. To wake the system from Suspend-To-RAM, just
press any key on the keyboard.
Save-To-File (Hibernation Mode)
There are four ways to perform Save-To-File (STF):
•
Press the Hot Keys <Fn> <F5>.
•
Allow the system to invoke this action, by setting the Auto Suspend Time Out,
and setting the Suspend Mode to Save-To-File (STF) in Chapter 11.6.
•
Press the system's power switch for less than 4 seconds.
•
System would perform Save-To-File (STF) automatically when system entering
Battery LOW 2. For detail on Battery LOW 2, refer to Chapter 6.4.
When Save-To-File (STF) is invoked, all data in memory and system status will be
saved to the Save-To-Disk file (refer to Chapter 10.1). The system will shut the power
down automatically. When you power-on the computer again, you will return exactly
where you left off.
Note:
For more information on Suspend(-To-RAM), and Save-To-File (STF),
refer to Chapter 11.6 and Chapter 10.1. For more information on Hot Keys,
see Appendix B.
Note:
If the file for Save-To-File (STF) has not been created, system would
actually perform a Suspend(-To-RAM) when a Save-To-File (STF) request
is issued.
Information in this document is subject to change without notice!!!
Battery
Page 6-5