Changing The Chimney Connection - RAIS/attika Q-Tee II GAS Bedienungsanleitung

English
PLEASE NOTE!
The floor construction must be able to bear the weight of the stove and
chimney, if applicable. If the existing design does not satisfy this prereq-
uisite, suitable measures must be taken (e.g., a load distribution slab).
Consult a construction expert.
The stove must be positioned at a safe distance from flammable materi-
al.
It must be ensured that flammable objects (e.g., furniture) are not po-
sitioned closer than the distances stated in the following sections with
regard to installation (risk of fire).
When you choose where you wish to position your stove, you should
consider the heat distribution to the other rooms. Then you will get the
maximum possible pleasure from your stove.
Inspect the stove for defects upon receipt.

Changing the chimney connection

The stove is supplied ready for a top outlet but can be changed to a
rear outlet in the following manner:
12
attika
RAIS/ - User manual for Q-Tee II Gas / Q-Tee II C Gas
1. The knock-out blank at the rear of the stove
can be knocked out using a hammer. This may
require several blows. Be careful to only hit the
blank.