AirSep VisionAire 5 Gebrauchsanweisung Seite 170

EN VisionAire™
8.0 Conformity with EN 60-601 ( § 6.8.2 b) / Classification
§
"The manufacturer, assembler, installer or importer are not considered to be responsible
themselves for the consequences on the safety, reliability and characteristics of a device
unless:
- The assembly, fitting, extensions, adjustments, modifications or repairs have been
performed by persons authorized by the party in question,
- The electrical installation of the corresponding premises complies with IEC regulations.
- The device is used in accordance with the instructions for use. "If the replacement parts
used for the periodic servicing by an approved technician do not comply with the
manufacturer's specifications, the latter is absolved from all responsibility in the event of an
accident. Do not open the device while in operation: risk of electrical shock. This device
complies with the requirements of the MDD(93/42/EEC:2007/47/EC) Annex I European
directive but its operation may be affected by other devices being used close by, such as
diathermy and high frequency electro-surgical equipment, defibrillators, short wave therapy
equipment, mobile telephones, CB and other portable devices, microwave ovens, induction
plates or even remote control toys and more generally electromagnetic interferences which
exceed the levels specified by the ECN 60601-1-2 standard.
®
EN-30 AirSep Corporation
MN137-1 rev. C - 02/13