Description Of Instruments - Benelli BN 251 Benutzerhandbuch

EN

DESCRIPTION OF INSTRUMENTS

Injection diagnostic light "FI"
When the switch is on and the vehicle is
not running, the light will switch on red,
to show that the injection system is ope-
rated correctly, when the vehicle is star-
ted the light is switch off.
WARNING:
If the light begins to flash while the
vehicle is being started, contact your
nearest Benelli assistance centre to
avoid damaging the engine.
High beam indicator light
A blue light switches on when the high
beam is on.
Neutral gear indicator light
A green light that switches on to show
that the gear pedal is in neutral.
Position indicator light
Green and flashing to show the use of
the left and right position indicators.
Rev counter
The rev counter shows the running
turnover of the engine so that the rider
can keep it within the ideal power range
Coolant temperature gauge
Shows the coolant temperature in °F
(Fahrenheit) or C°(Celsius).
WARNING:
If the coolant temperature gauge begins
to flash, stop the vehicle and run it at a
minimum until the temperature of the
coolant drops.
If the temperature does not drop, switch
off the engine.
78
Digital clock
Shows the time in hours and minutes.
Digital clock setting
Press and hold down the "RESET"
button for 3 seconds until the reading
begins to flash.
Adjust the hour by pressing
"SELECT" button.
Press the "RESET" button to pass on to
adjust the minutes (tens and then units).
Adjust the minutes by pressing the
"SELECT" button.
Press the "SELECT" button again to
quit.
Fuel gauge
The digital fuel gauge shows the capaci-
ty of the fuel tank. As the fuel level
drops, the lines on the gauge will
become closer and closer to the "E"
reserve area. As soon as the final line
starts to flash, there is an autonomy of
about 3 litres of fuel.
Speedometer
Indicates the vehicle's speed in km/h or
mph. To pass from one to the other,
press the SELECT" button.
the