Use Of The Remote Control - Carrier 40KQM Gebrauchsanweisung

40KQM

Use of the remote control

WARNING :
In case of loss or failure of the remote control, address to
skilled personnel.
Current time adjusting
(buttons N and O)
Press current time adjusting button
adjust the current time.
Press reset button "O" with a sharp object if the remote control is
not operating properly or after replacing the batteries.
Setting current time
(button )
1.
With the remote control ON or
OFF, press button for at least
5 seconds.
2.
The current hour figure flashes.
Press either button or
to set the current hour.
Press button to move to
minutes and set them.
3.
For this setting always use
either button or .
4.
Once the current time is set,
press button to confirm it.
Start / Stop
(button B)
When the air conditioner is not in operation, the remote control
readout will display the time of day only (in case other symbols are
lit, turn control off by pressing button
Press button to start the air conditioner.
All selected and memorized functions will light up and appear; the
unit will operate according to the functions selected.
Press button to stop the air conditioner.
All indicators on the unit will go out, and the control will display
only the current time.
If the unit does not stop, turn the control on (by pressing button
) and repeat the operation.
If button (air conditioner starting) is pressed too soon after a
stop, the compressor will not start for 3/5 minutes due to the
inherent protection against frequent compressor cycling.
The unit will only emit a "beep", when the signals are received
correctly.
and reset buttons
for at least 5 seconds to
A 1
B 2
PM
A 1
B 2
).
Selection of the operating mode
(button A)
With this button the operating mode of the air conditioner can be
selected.
By repeatedly pressing this button the available modes will be
selected in sequence.
The choosen mode is shown as follows, while the unit will
acknowledge signal receipt with a confirming beep.
Indicated Symbol
Ventilation (fan only).
Heating.
Automatic.
Cooling with dehumidification.
Dehumidification only.
Temperature setting
UP
(button C)
DOWN
(button D)
Pressing the UP and DOWN
decrease the temperature from the previously set value.
The unit will confirm signal receipt with a beep, and the value of
the set temperature on the display will change accordingly.
The temperature can be set between 17°C (63°F) and 32°C (90°F)
at 1 degree intervals.
In cooling mode, if the temperature selected is higher than the
room temperature the unit will not start; the same applies for the
heating mode, if the selected temperature is lower than the room
temperature.
Selecting direction of air flow louvre
(button H)
The air flow direction can be adjusted to optimize air distribution in
the room.
Press button repeatedly to choose one of the following louvre
positions:
Symbol on display
Air direction will be set automatically.
Louvre will be set to the preset position according to the
operation mode.
6 positions can be chosen.
The louvre can be set to one of 6 different air
flow directions.
The louvre will continuously swing up and down.
"Swing" always assures optimal even air distribution in the
room.
E N G L I S H
buttons will increase or
GB - 7