Werbung
20°
16,5°
7°
00:00
EN
8.0 - On the ' Prog ' page you can program the timer
for each day of the week, choosing up to 6 slots to
activate in 3 ways.
"Comfort" "Eco" and "Frost Protection" [1].
1) Select "Settings".
Press the arrow keys and select "Prog". Press "OK" to
confirm. (Fig. 8A )
First select the day of the week. Press "OK", wait until
the display flashes.
Scroll with the arrow keys select the day e .g Sunday.
Press "OK" to confirm.
2) Select F1 range, using the arrow keys. ( Fig. 8B )
Press "OK" to confirm.
The activation for the f1 range appears on/off.
With the arrow keys select "on". ( Fig. 8C )
Press "OK" to confirm.
The start time and mode appears. ( Fig. 8D )
Set for example 07:00 and "comfort" (the temperature
was set in "comfort").
3) Select F2 range.
Set 'on' start time e.g. 09:30 and 'eco' mode.
4) Set 'on' start time e.g. 11:30 and 'frost protection'
function.
5) To summarise, with the first 3 ranges set, the screen
displays the time and mode set. Unset ranges remain
empty. (Fig. 8E)
F1
F2
07:00
09:30
F3
11:30
24:00
Summary (see diagram):
The Day selected : Sunday
At 07:00 (F1) range is on and the radiator is in
'comfort' mode.
At 09:30 (F2) range is on and the radiator is in 'eco'
mode.
At 11:30 (F3) range is on and the radiator is in 'frost
protection' [1] mode until 24:00.
Notes
• If you set a pre-existent time to the previous range
'ERR' will appear as you are entering a contradictory
instruction.
• If you set a time later than the following range, all
subsequent bands are disabled.
• The command of the last range enabled (F1. ... F6)
remains active until 00:00 of the same day.
• If no range is set then the radiator is in 'frost
protection'
[1] - 'Frost protection' mode is used when radiator is
off. It turns on only when ambient temperature drops
below 7°C.
Grafico programmazione
Graphic
Schaubild Programmierung
Programmation graphique
mode.
[1]
33
Werbung
