Virutex PEB150 Gebrauchsanweisung Seite 11

A
12
13
16
6. RECOMMENDATIONS BEFORE FIRST USING THE PEB150/
PEB50
• The edge of the board to be banded must be at 90º to the top
surface and free of dust.
• The edge must have a good surface to obtain a perfect finish
when banding chip boards with thin edges.
• The pieces and the edges that are going to be glued must be at
a temperature of at least 18°C.
• Always apply sufficient force on the edge to obtain a good
banding.
• Check that the quantity of glue that the edge receives is appro-
priate by doing a trial run.
• Do a trail run before banding concave or convex curves.
• The glue tank must be closed and dry.
• The glue gives off fumes when at working temperature. Make sure
these are eliminated by keeping the workplace well ventilated.
• Keep the machine free of dust or shavings. If the machine is
dirty you will obtain bad quality veneers.
• Make sure you have enough fully melted glue in the tank to
finish the job. If you have to add glue to the tank, activate the
feed system for around five minutes.
• When you are going to glue the edges, use Virutex special glue
for PEB150/PEB50, which has been specially developed for this
purpose.
• You can also use one of the following glues which have been
approved by Virutex for use in the PEB150/PEB50:
- Rayt type MA-6244
- Kleiberit 743.7
- Kleiberit VP9296/57
- Jawat 280.3
- Dorus KS224/2
• Virutex only guarantees that edgebander PEB150/PEB50 will work
correctly if one of the recommended glues are used.
• Hold the machine horizontally during and after use.
• Before starting the machine, check that the advance switch (A)
is in position "O".
• The glue control knob (13), and the glue tank lid (16) get bloc-
ked with glue when the machine cools down. Do not adjust the
knob or lift the lid until the machine is hot again and the glue
has melted.
11