WIKA DP-10 Betriebsanleitung Seite 31

7. Caractéristiques techniques
Specifications
Shock resistance
Suitable media
Sensor volume
Increase in volume
CE-conformity
{integrated indicator}
Digital

Analogue

{Alarm contacts}
Number

Switching function

Adjustability

 Switching accuracy
Switching repeatability

Switching hysteresis

Contacts

 Contact rating
{Root-evolved output signal}
Accuracy

Calculation

Electrical connection
Ingress of protection
Weight
Dimensions
Mounting
{ } Items in curved brackets are optional extras for additional price.
1) The measuring ranges 0 ... 0.1 mbar; 0 ... 0.25 mbar; 0 ... 0.4 mbar are available on request.
For these measuring ranges a larger measuring cell and consequently also a case with larger dimensions is required.
2) Only with 4 ... 20 mA 2-wire, other output signals on request.
WIKA Mode d'emploi Transmetteur de pression différentielle
Model DP-10
g 10
clean, non-aggressive, dry gases
ml approx. 5 (approx. 7 for measuring ranges < 2.5 mbar)
ml approx. 1 at nominal pressure
Interference emission and immunity see EN 61 326 / A1;
declaration of conformity on request european guideline for
low voltages EN 610 10
LC display, 3 ½-digits; height of digits 10 mm, pick-up rate
3/sec.
analogue indicator 0 ... 100 %
only with 3-wire systems
1 or 2
standard setting 2 x max.
1 ... 100 % of span
≤ 1 % of span
0,2 % of span, typical
0 ... 10 % of span, adjustable
1 potential-free relay change-over contact per alarm contact
AC 6 A, 230 V with ohmic load
1,0 % of span
the root is evolved according to the following equations:
U = √ 10 x U )
R L
I = 20 x I )
R L
via cable gland PG 7 and internal screw terminals in the
bottom part of the case, terminal champing diameter 1.5 mm²
IP54, per EN 60 529 / IEC 529
kg approx. 0.6 {approx. 0.7 with power supply}
mm see drawings
case for wall mounting
U = linear output 0 ... 10 V
L
I = linear output 0 ... 20 mA
L
F
31