Binding; Setting Up The Machine; Placing Pages In The Binding Cover - LEITZ impressBIND 140 Gebrauchsanweisung

1
2
3
4
6


Binding

1.

Setting up the machine

• Carefully place the machine on a stable surface.
• Move the binding lever
• The machine is now ready to use.
2. Determining the correct spine width
• Raise the measuring device
below it.
• Let the measuring device down again and read off the recommended
spine width from the scale.
• Take out the pages.
The spine width is indicated on the metal strip in the binding cover.
Number of pages
(80 g/m²)
15–35
36–70
71–105
106–140
3.

Placing pages in the binding cover

• Straighten the pages so that the edges are flush.
• Insert the pages into the binding cover.
• Make sure that the space between the pages and the upper and lower
edge of the binding cover are identical.
4. Binding
• Make sure that the binding lever
• Place the binding cover in the binding tray.

Caution, danger of crushing fingers/hands! When binding, hold
the binding cover with one hand and the lever with the other hand and
keep other persons away from the machine.
• Press the binding lever
lever only upwards to the first stop.
• Move the lever fully upwards again and remove the bound book.
A de-binder, 7448-00-00, is available as a separate item. You can use this
accessory to reopen a bound book up to three times in order to remove or add
pages.
upwards.
A
and place the pages to be bound
E
Spine width
of binding cover
3.5 mm
10.5 mm
14 mm
is pushed up as far as it will go.
A
down four times. While doing so, move the
A
7 mm