Punching And Binding With Plastic Combs - LEITZ comBIND 500e Gebrauchsanweisung

1
2
3
4
5

Punching and binding with plastic combs

Preparations
• Set the paper stop
• Determine the comb size needed by holding the document
scale .
You may also use the table on page 5 for this purpose.
• Set the punching depth
2. Inserting and opening the comb
• Place the plastic comb with the side to be opened facing upwards
into the binding mechanism
• Pull the binding lever
that the sheets can be easily inserted.
3. Punching the sheets
Tip: We recommend testing the punch setting using a blank sheet of paper
before punching the original document.
Caution! To prevent damage to the motor and punching
document before punching. Do not punch more than 28 sheets of
cuttings tray regularly.
• Insert the sheets into the rear slot
• Press the punching button
• Remove the punched sheets.
4. Inserting the sheets
• Insert the punched sheets into the opened comb.
It is now possible to punch all remaining sheets (step 3) and insert them into
the opened comb.
5.
• Push the binding lever
•
to the paper format used.
according to the comb size determined.
.
so far until the comb is opened enough so
.
.
backwards to close the comb.
7