Toshiba RAV-GM561UT-E Bedienungsanleitung Seite 61

 How to cancel louver lock
Set the wind direction to "0000" of the louver lock setup
procedure above.
Setting data
0000
• When the setting is canceled, goes out.
Other operations are the same as those in "How
to set up louver lock (No swing)".
 Remote controller sensor
The temperature sensor of the indoor unit senses room
temperature usually. Set the remote controller sensor
to sense the temperature around the remote controller.
Select items following the basic operation procedure
1 2 3 4 5 6
    
( ).
[32]
• Specify for the CODE No. in Procedure
• Select the following data for the SET DATA in
4
Procedure .
SET DATA 0000
Remote controller Not used
sensor (factory default)
When flashes, the remote controller sensor is
defective.
Select the SET DATA [0000] (not used) or replace the
remote controller.
119-EN
 To select horizontal wind
direction
1. Push and "TEMP." buttons for at least four
seconds when the air conditioner is not working.
flashes.
[01]
Indicates CODE No. .
2. Select an indoor unit to be set by pushing
button (left side of the button).
Indoor unit number changes each time you push the
button.
UNIT No. UNIT No.
1-1 1-2
No UNIT No.
display 1-4
The fan of the selected unit runs and the louvers
start swinging.
[45]
3. Change the CODE No. to
buttons.
4. Select wind direction setting with "TIME"
buttons.
3
.
Wind
direction SET Wind direction setting
DATA
Smudge reducing position
0000
0001 (Air direction to reduce ceiling
contamination) [Factory default]
Used
Cold draftless position
0002
(Air direction to control cold air fall)
5. Push button to check the setting.
The display state changes from flashing to lighting,
and the setting is fixed.
6. Push button to end the setting.
* When the cold draft position is selected, ceiling
contamination is less reduced.
 Power saving mode
Performing settings of the power saving
mode
1
Push
when the air conditioner is not working.
flashes.
Indicates CODE No.
2
Select an indoor unit to be set by pushing
UNIT No.
(left side of the button).
1-3
Each time the button is pushed, unit numbers
change as follows:
UNIT No.
1-1
with "TEMP."
The fan of the selected unit runs.
3
Adjust the power save setting by pushing
TIME
Each push of the button changes the power level
by 1% within the range from 100% to 50%.
*The factory default is 75%.
4
Determine the setting by pushing
5
Push button to complete the setting.
– 60 –
 Remote controller switch
monitoring function
This function is available to call the service monitor
mode from the remote controller during a test run to
acquire temperatures of sensors of the remote
button for 4 seconds or more
controller, indoor unit, and outdoor unit.
[C2.]
2
UNIT No. UNIT No.
1-2 1-3
4
UNIT No.
1-4
1
Push
at least 4 seconds to call the service monitor
buttons. mode.
The service monitor indicator lights up and the
header indoor unit number is displayed first.
CODE No.
2
Pushing TEMP.
number of sensor (CODE No.) to be
monitored. (See the following table.)
3
Pushing
select an indoor unit to be monitored. The
sensor temperatures of indoor units and
Setting of power level in
their outdoor unit in the control group are
power saving mode
displayed.
4
button.
Push
display.
1 3
and buttons simultaneously for
is also displayed.
buttons, select the
(left side of the button),
button to return to the normal
120-EN