Toshiba RAV-GM561UT-E Bedienungsanleitung Seite 58

▼ Seal material of wiring
connecting port
Remote control Indoor/Outdoor connecting wires
wiring
Side D (height: 8.5 mm)
Side C (height: 4 mm)
Clamp the power supply cable according to the table below
based on the thickness and type.
* The clamp can be mounted on the right or left reverse.
Clamp two cables side-by-side for twin connection.
Cable clamping
Wire type Specification
4-core stranded
wire 2.5 mm²
Cabtyre cable
4-core stranded
wire 1.5 mm²
113-EN
Seal the clearances of each
wiring connecting port with
the attached seal material.
Seal material
Power supply terminal board
1 2 3
Remote controller
terminal board
Earth screw
position
Side D
Side C
Cord clamp
– 57 –
 Remote controller wiring
Strip off approx. 9 mm the wire to be connected.
Wiring diagram
A B
 Wiring on the ceiling panel
As per the Installation Manual of the ceiling panel, connect the connector (20P: White) of the ceiling panel to the
connector (CN510: White) onto the P.C. board within the electrical control box.
10 1 2 3
10
70
50
Indoor / Outdoor connecting wires
Earth wire
Indoor / Outdoor connecting wires
Terminal block for
remote controller
wiring of indoor unit
A
B
Remote controller wire
(Locally procured)
See the figure on the left for
system interconnection wires to
the terminal block.
Terminal block
Remote
A
controller
B
unit
114-EN