Maintenance And Cleaning; Changing The Gripper Jaws - Parkside PDBNP 14 B1 Originalbetriebsanleitung

♦ Proceed in the same way with the other rivets
.
♦ Empty the pin collector
♦ When you have finished working, disconnect
the appliance from the compressed air source.

Maintenance and cleaning

WARNING! RISK OF INJURY! Discon-
nect the appliance from the com-
pressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the appliance.
Avoid all skin contact with these substances.
If the skin comes into contact with hazardous
dusts, this can lead to severe dermatitis.
► The dust and vapours produced by using
the appliance can be hazardous to health
(e.g. cause cancer, birth defects, asthma
and/or dermatitis); it is essential to carry out
a risk assessment in respect of these risks
and to implement corresponding regulatory
mechanisms.
NOTE
To ensure correct functioning and long-term
durability of the rivet gun, pay attention to the
following points:
■ Sufficient and continuously intact oil lubrication
is highly important for optimum functioning.
■ Use only the genuine replacement parts rec-
ommended by the manufacturer, otherwise you
could put users at danger. In doubt, contact the
Service Centre.
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of the rivet gun.
■ Only clean the appliance with a soft, dry cloth
or with compressed air.
■ Never use sharp or scratchy cleaning agents
under any circumstances.
PDBNP 14 B1
regularly.

Changing the gripper jaws

Friction can wear out the gripper jaws
happens, replace the worn gripper jaws
the supplied spare gripper jaws
♦ Unscrew the front connector
sembly spanner , if necessary. This gives you
access to the following parts:
A B C E
A Appliance shaft
B Lock nut
C Lock washer
E Two-piece metal cone
G Gripper jaws
♦ Unscrew the two-piece metal cone (E) holding
the gripper jaws (G) from the shaft (A), using
the two assembly spanners
sary.
♦ Using both assembly spanners,
unscrew the front piece of the metal cone from
the back piece (E2, E1). This gives you access
to the following parts:
A B C D
A Appliance shaft
B Lock nut
C Lock washer
D Spring
E1 Back piece of the metal cone
F Expanding mandrel
G Gripper jaws
E2 Front piece of the metal cone
♦ Remove the expanding mandrel (F) and the
worn gripper jaws (G) from the front piece of
the metal cone (E2).
. If this
with
as follows.
using the as-
G
and if neces-
and ,
E1 F G
GB │ IE │
21
E2
■