General Safety Warnings For Compressed Air Tools; Hazards Caused By Flying Parts - Parkside PDBNP 14 B1 Originalbetriebsanleitung

Noise emission value:
Noise measurement determined in accordance
with ISO 15744.
The rated noise level of the tool is typically:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear hearing protection!
Total vibration value:
Vibration values determined in accordance with
ISO 28927-6 and EN 12096:
Vibration emission value a
Uncertainty K = 0.59 m/s
h
NOTE
► The noise emission levels and vibration values
specified in these instructions have been mea-
sured in accordance with the corresponding
standardised measuring procedure and can
be used to make equipment comparisons.
The noise emission levels and vibration values
vary depending on the use of the compressed
air tool and may be higher than the values
specified in these instructions in some cases.
It is easy to underestimate the noise emission
levels and vibration values if the compressed
air tool is used regularly in this manner.
PDBNP 14 B1
L = 76.1 dB (A)
pA
K = 3 dB
pA
L = 87.1 dB (A)
WA
K = 3 dB
WA
≤ 0.85 m/s 2
h
2
WARNING! General safety warnings
for compressed air tools
WARNING!
► For multiple hazards: Please ensure that you
have read and understood the safety informa-
tion before setting up, operating, repairing,
maintaining and replacing accessories on the
machine and before working in the vicinity of
the machine for threadless fasteners. Failure
to do this can result in serious bodily injury.
■ The machine should only be set up, adjusted
or used by suitably qualified and trained
operators.
■ This machine for threadless fasteners may not
be modified in any way. Modifications can
reduce the effectiveness of the safety measures
and increase the risks for the operator.
■ The safety instructions should not be lost – give
them to the operator.
■ Never use damaged machines for threadless
fasteners.
■ The appliance must be inspected regularly to
ensure that it is labelled with the required rated
values and markings given in this manual. The
user must contact the manufacturer to obtain
replacement labels if necessary.
Hazards caused by flying parts
■ Disconnect the machine for threadless fasteners
from the power supply before replacing the
machine tool or accessories.
■ If a workpiece or accessory or even part of the
machine tool itself breaks, parts can be flung
off at high speeds.
■ Always wear impact-resistant eye protection
when operating the machine. The level of pro-
tection required should be assessed separately
for each use.
■ In this case, the risks for others should also be
assessed.
■ You must ensure that the workpiece has been
securely fixed in place.
■ Check whether protection against ejection of
fastening elements and/or rivet shafts is avail-
able and effective.
GB │ IE │
17 ■