Parkside PDBNP 14 B1 Originalbetriebsanleitung Seite 25

♦ Place the new gripper jaws (G) into the front
piece of the metal cone (E2) such that the nar-
row ends protrude from its opening.
NOTE
Both gripper jaws (G) must protrude from the
opening flush with each other. We recommend
that you hold the front piece of the metal cone
(E2) vertically, with the gripper jaws (G) pointing
downward.
♦ Insert the expanding mandrel (F) such that its
tips are inside the notch formed by the rear
ends of the gripper jaws (G).
♦ Using both assembly spanners,
screw the front and back piece of the metal
cone (E2, E1) together.
♦ Screw the metal cone (E) back onto the appli-
ance shaft (A) and tighten it using the assembly
spanner . Use the assembly spanner
lock the lock nut (B).
♦ After installing the metal cone (E), check the dis-
tance between the thread and metal cone (E). It
should be approximately 70 mm. You can use
the assembly spanner
necessary, adapt the measurement by adjusting
the lock nut (B).
B
ca. 70 mm
♦ To attach the front connector
the thread (you will feel minor resistance) and
tighten it by hand.
♦ Tighten the front connector
bly spanner .
│ GB │ IE
■ 22
and
as a measuring aid. If
E
, press it onto
using the assem-
,
to
PDBNP 14 B1