Herunterladen Inhalt Inhalt Diese Seite drucken

Fuel Solenoid; Ground Pressure; Hydro Neutral - Jacobsen HR 5111 Turf Mower Sicherheits Und Bedienungs Anleitung

With rops product number: 69116 - engine type: kubota v2203 with rops & cab product number: 69129 - engine type: kubota v2203
Inhaltsverzeichnis

Werbung

TRACTOR ADJUSTMENTS

9.7 FUEL SOLENOID____________________________________________________________

3/64-1/16"
(1 - 1.5 mm)
HR15

9.8 GROUND PRESSURE

Leaving a tractor running and
!
WARNING
unattended can be fatal or
cause serious injury.
To prevent injury, lower mowers to the ground,
disengage all drives, engage parking brake and
stop engine before making any adjustments.
1. Adjusting ground pressure affects lowering time of lift
arms and also affects ground pressure at each tire.
2. Loosen thin knob (F) and adjust large knob (G) to
increase or decrease cutting unit weight.
a. The valve adjusts all mowers simultaneously.
b. Decreasing cutting unit weight increases tractor
weight, which increases traction on slopes.

9.9 HYDRO NEUTRAL

If the tractor "creeps" in either direction, the "neutral"
position must be adjusted. The tractor may tend to
"creep" if transmission oil is cold. Operate tractor for 15
minutes before determining if adjustment is required.
Carbon
!
WARNING
exhaust fumes can be fatal
when inhaled.
Any adjustments or repair performed while the
engine is running must be made with ample
ventilation.
Never work on a vehicle that is supported only by
the jack. Always use jack stands and make sure
the tractor is on solid and level ground.
If only one end of the tractor is raised, place
chocks in front of and behind the wheels that are
not raised.
1. Place small amount of lubricating oil on all linkage
pivot points.
GB-22
Figure 9E
E
4-5/8"
(102 mm)
___________________________________________________________________
_______________________________________________________________________
monoxide
in
TEXTRON TURF CARE AND SPECIALTY PRODUCTS
Adjust rod (E) so fuel solenoid locks into hold
positionwhen ignition key is in "on/run" position. Maintain
a 3/64-1/16 in., (1-1.5 mm) gap between lever and boss
whenin "Stop" position.
If wing weight is set too light, cutting units will not
lower to ground from transport position.
c.
Once desired ground pressure has been
obtained, tighten thin knob (F).
F
G
H
the
N
H
Note:
INCREASE
DECREASE
K
J
L
P
Must Be Parallel
Figure 9F
HR16
Figure 9G
M
HR05

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis