Battery - Charging; Care And Cleaning; Electrical System - Jacobsen HR 5111 Turf Mower Sicherheits Und Bedienungs Anleitung

MAINTENANCE
4. Tighten cables securely to battery terminals and
apply a light coat of silicone dielectric grease to
7.3 BATTERY – CHARGING ______________________________________________________
Battery acid is very caustic
!
WARNING
and fumes are explosive and
can cause serious injury or death.
Charge battery in a well ventilated area.
Batteries generate explosive gases. To prevent
an explosion, keep any device that may create
sparks or flames away from the battery.
To prevent injury, stand away from battery when
the charger is turned on. A damaged battery
could explode.
Always use insulated tools, wear protective
glasses or goggles and protective clothing when
working with batteries. You must read and obey
all battery manufacturer's instructions.

7.4 CARE AND CLEANING _______________________________________________________

1. Wash the tractor and implements after each use.
Keep the equipment clean.
Washing hot equipment can cause
CAUTION
component damage.
Do not wash any portion of the equipment while it
is hot. Do not use high pressure spray or steam.
Use cold water and automotive cleaners.
2. Use compressed air to clean radiator and engine.
Section 7.12 and Section 7.16.
3. Do not spray water directly at the instrument panel,
electrical components or at bearing housings and
seals.
4. Clean all plastic or rubber trim with a mild soap
solution or use commercially available vinyl/rubber
cleaners.

7.5 ELECTRICAL SYSTEM _______________________________________________________

Always turn the ignition switch off and remove the
negative battery cable before inspecting or working on
the electrical system.
1. Check the operator back-up system, fuses and circuit
breakers regularly.
Leaving a tractor running and
! WARNING
unattended can be fatal or
cause serious injury.
Never operate equipment with the operator back-
GB-12
TEXTRON TURF CARE AND SPECIALTY PRODUCTS
terminals and cable ends to prevent corrosion. Keep
terminal covers in place.
Make absolutely certain the ignition switch is
"OFF" and the key has been removed before
servicing the battery.
1. Refer to the Battery and Charger's manual for spe-
cific instructions. Read Section 7.2.
2. Whenever possible, remove the battery from the
tractor before charging and make sure the electro-
lyte covers the plates in all the cells.
3. Make sure the charger is "OFF", then connect the
charger to the battery terminals as specified in the
charger's manual.
4. Always turn the charger "OFF" before disconnecting
the charger from the battery terminals.
5. Repair damaged metal surfaces and use Jacobsen
"Orange" touch-up paint. Wax the vehicle for
maximum paint protection.
NEVER use your hands to
! WARNING
clean cutting unit. Use a brush
to remove grass clippings from blades. Blades
are extremely sharp and can cause serious
injuries.
Clean grass and debris from
!
CAUTION
cutting unit, drives, mufflers,
and engine to prevent fires. Clean up oil or fuel
spillage. Do not store tractor near open flame.
up system disconnected or malfunctioning. Do
not disconnect or bypass any switch.
2. If the operator back-up system does not function
properly, or the problem cannot be corrected,
contact an Authorized Jacobsen Distributor.
3. Make certain all terminals and connections are kept
clean and properly secured.
4. Keep the wire harness and all individual wires away
from moving parts to prevent any type of damage.