Operating Modes; Cleaning, Maintenance And Ordering Of Spare Parts; Technical Data; Disposal And Recycling - EINHELL WSE 230/5 Bedienungsanleitung

Anl WSE 230-5_SPK1:_ 01.03.2007
specified diameter.
Before using a grinding or cutting wheel, check its
rated speed. The wheel´s rated speed must be
higher than the idle speed of the right-angle grinder.
Use only grinding and cutting wheels that are
approved for a minimum speed of 6,000 rpm and a
peripheral speed of 80 m/sec.

OPERATING MODES

Rough grinding:
For the best rough grinding results, hold the grinding
wheel at an angle of between 30° and 40° to the
workpiece surface and guide back and forth over the
workpiece in steady movements.
Cutting:
When you use the right-angle grinder for cutting
purposes, avoid tilting it in the cutting plane. The
cutting wheel must have a clean cutting edge.
A diamond cutting wheel is best used to cut hard
stone.
It is prohibited to use the machine on asbestos
materials!
Never use a cutting wheel for rough grinding.

TECHNICAL DATA

Nominal voltage 230 V ~ 50 Hz
Power consumption
Idle speed
Max. wheel diameter
Drive spindle thread
Sound pressure level L
pA
Sound power level L
WA
Vibration a
hv
Weight
Totally insulated
9:18 Uhr Seite 7
Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
2350 W
Type of machine
6.000 rpm
Article number of the machine
230 mm
Identification number of the machine
M 14
Replacement part number of the part required
94 dB(A) For our latest prices and information please go to
www.isc-gmbh.info
107 dB(A)
4,83 m/s 2

Disposal and recycling

5,1 kg
The unit is supplied in packaging to prevent its being
II /
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
7