Environmental Information - Rema Tip Top PROMAXX 8150 Betriebsanleitung

DaNGEr
Before carrying out any maintenance opera-
tion or topping up with lubricant, disconnect
the machine from the compressed air supply
line.
Check the lubricant level periodically through
the windows provided and top up as shown in
fig.32c. Top up only with SAE20 non detergent
oil to a total quantity of 50 cc.
The FR filter regulator unit is equipped with
an automatic system for drainage of the con-
densation water, so in normal conditions it
does not require any particular maintenance.
However, the water may be drained by hand at
any time (fig.32d).
Normally it is not necessary to remove the
cups, but this may be necessary after long pe-
riods out of use; if the cup cannot be removed
with the hands only, use the spanner provided
(fig.32e).
Clean with dry cloth. Avoid contact with sol-
vents.
aTTENTioN
Keep the work area clean.
Do not clean the machine with compressed
air or jets of water.
When cleaning the area avoid raising dust as
far as possible.
30
ENViroNmENTaL
iNFormaTioN
The following disposal procedure shall be
exclusively applied to the machines having
the crossed-out bin symbol
data plate.
This product may contain substances that can
be hazardous to the environment or to human
health if it is not disposed of properly.
We therefore provide you with the following
information to prevent releases of these su-
bstances and to improve the use of natural
resources.
Electrical and electronic equipment should
never be disposed of in the usual municipal
waste but must be separately collected for
their proper treatment.
The crossed-out bin symbol, placed on the
product and in this page, remind you of the
need to properly dispose of the product at the
end of its life.
In this way it is possible to prevent that a not
specific treatment of the substances contained
in these products, or their improper use, or im-
proper use of their parts may be hazardous to the
environment or to human health. Furthermore
this helps to recover, recycle and reuse many
of the materials used in these products.
For this purpose the electrical and electronic
equipment manufacturers and dealers set up
proper collection and treatment systems for
these products.
At the end of life of your product contact your
dealer to have information on the collection
arrangements.
When buying this new product your dealer will
also inform you of the possibility to return free
of charge another end of life equipment as long
as it is of equivalent type and has fulfilled the
same functions as the supplied equipment.
A disposal of the product different from what
described above will be liable to the penalties
prescribed by the national provisions in the
country where the product is disposed of.
- E
on their
- Operator's manual
nglIsh