Specified Conditions Of Use; Main Operating Parts Of The Machine - Rema Tip Top PROMAXX 8150 Betriebsanleitung

SPECiFiED CoNDiTioNS
oF USE
The PROMAXX 8150 tyre changers have been
designed for the exclusive purpose of mounting
and demounting tyres using the tools with which
it is equipped and following the instructions
given in this manual.
WarNiNG
any other operations carried out on the ma-
chine are considered improper use and shall
be construed as negligence.
The machine is equipped with an inflation system
that is independent from the systems described
above. Extreme caution must be exercised
during the use of the machine inflation system
(read INFLATION heading).
WarNiNG
When working with the machine it is strongly
recommended to avoid using equipment or to-
ols not manufactured by the manufacturer .
Figure 6 shows the positions assumed by the
operator during the various stages of work with
the machine:
A Bead breaker
B Tyre demounting and mounting
C Inflation area.
WarNiNG
To stop the machine in an emergency:
- unplug from the electrical supply;
- isolate the air supply network by discon-
necting the shut-off valve (rapid insert)
(fig.6a).
24
maiN oPEraTiNG ParTS oF
THE maCHiNE
WarNiNG
Get to know your machine: the best way to
prevent accidents and obtain top performance
from the machine is to ensure that all opera-
tors know how the machine works.
Learn the function and location of all com-
mands.
Carefully check that all the commands on the
machine are working properly.
To avoid accidents and injury, the machine
must be installed properly, operated correctly
and serviced regularly.
Fig.7
A VERTICAL SLIDE ARM - for the positioning of
the mount/demount device.
B HORIZONTAL SWING ARM - moves the mount
demount device and the table top vertical
slide away for the removal or replacement
of tyres or rims.
C MOUNT/DEMOUNT DEVICE - for mounting/
demounting the tyre on the rim.
E TABLE TOP - rotating device for clamping
the wheels.
F TABLE TOP PEDAL - three-position pedal that
controls the rotation of table top in both
directions.
G CLAMP CONTROL PEDAL - three-position
pedal for opening, closing and moving in
rim clamps.
H BEAD BREAKER PEDAL - two-position pedal
for operation of bead breaker.
L BEAD BREAKER SHOE - mobile shoe for de-
taching bead from rim.
M LEVER - for locking the vertical slide arm
after finding the exact position for the C-D
device.
N KNOB - for setting the horizontal swing arm,
maintaining the "C-D"/rim distance.
O AIR TANK - FI version only.
P INFLATOR GUN
Q INFLATOR PEDAL - FI version only.
R PRESSURE GAUGE BOX (FI version only)
S DOYFE UNION
T OPERATING PRESSURE GAUGE
U DEFLATION BUTTON (FI version only)
- E - Operator's manual
nglIsh