Trouble Shooting - Rema Tip Top PROMAXX 8150 Betriebsanleitung

TroUBLE SHooTiNG

Table top will not rotate.
Power cord conductor shorting to ground.
> Check the wiring.
motor shorted.
> Renew the motor.
rotation control pedal fails to return to the
central position
Control spring broken.
> Renew the spring.
Bead breaker pedal and table top pedal do
not return to home position
Control spring broken.
> Renew the spring.
No oil in lubricator.
> Top up lubricator with SAE20 non-detergent
oil.
air leak inside the machine
air leak from bead breaker cock.
> Renew the cock.
> Renew bead breaker cylinder.
air leak from the table top cock.
> Renew table top cylinder.
> Renew swivel connector.
Bead breaker cylinder lacks force, fails to
break beads and leaks air
Silencer plugged.
> Renew silencer.
Cylinder seals worn.
> Renew seals.
> Renew bead breaker cylinder.
Bead breaker cylinder leaks air around the
air seal worn.
> Renew seals.
> Renew bead breaker cylinder.
28
rod
Table top will not rotate in either direction
inverter faulty.
> Replace inverter (microswitch for 2V).
Belt broken.
> Renew belt.
Gear unit broken.
> Renew gear unit.
Gear unit noisy. The table top makes 1/3 of
a revolution and then stops
Gear unit seizing.
> Renew gear unit.
Table top fails to clamp wheels
Table top does not clamp rim.
> Renew table top cylinder.
Clamp grippers are worn.
> Renew clamp grippers.
Table top mounts or demounts tyres with
difficulty
Insufficient belt tension.
> Adjust belt tension (fig.23) or renew it.
Vertical slide lifts too little or too far from
Clamping plate not adjusted.
> Adjust plate.
Vertical slide ascends under strain
Defective clamping plate.
> Renew plate.
Clamping plate not adjusted.
> Adjust plate.
When the tower tilts back, the arm and
vertical slide slip to their limit stops
Defective clamping plate.
> Renew plate.
Clamping plate not adjusted.
> Adjust plate.
Vertical and horizontal limit stops do not
operate
No air passage through cock.
> Renew cock.
- E
rim
- Operator's manual
nglIsh