Safety Regulations - Rema Tip Top PROMAXX 8150 Betriebsanleitung

- The user must equip the machine with the
following:
• a dedicated power plug in compliance with
the relevant electrical safety standards;
• a type A and B suitable circuit-breaker (re-
sidual current set to 30 mA) on the mains
connection;
WarNiNG: only a type a and B differential
security breaker of the specified kind will be
tripped correctly in response to all the failure
currents which may occur on the machine.
• power line fuses in accordance with speci-
fications in the main wiring diagram of this
manual;
• a suitable earthing system installed on the
workshop mains line.
- To prevent unauthorised use of the machine,
always disconnect the mains plug when the
machine is not used (switched off) for extended
periods of time.
- If the machine is connected directly to the
power supply by means of the main electrical
panel and without the use of a plug, install
a key-operated switch or suitable lock-out
device to restrict machine use exclusively to
qualified personnel.
For correct operation of the machine the com-
pressed air supply line must provide a pressure
range from a minimum of 8 bar to a maximum
of 16 bar.
NoTE
The machine is equipped with a pressure regula-
tor set at 10 bar (standard machine operation).
If you are working with easily deformable rims
(motor cycle wheels for example) we recom-
mend lowering the pressure temporarily to 7
or 8 bar.
aTTENTioN
For correct and safe operation of the ma-
chine it must be connected to an efficient
grounding circuit.
NEVEr connect the ground wire to a gas
pipe, water pipe, telephone line or other
makeshift system.
22

SaFETY rEGULaTioNS

The equipment is intended for professional
use only.
WarNiNG
only one operator may work on the equip-
ment at a time.
WarNiNG
Failure to observe these instructions and the
relative danger warnings can cause serious
injury to the operator and others. Do not
power up the machine before you have read
and understood all the danger/warning/at-
tention notices in this manual.
This machine must be used only by qualified
and authorised personnel. A qualified operator
is construed as a person who has read and
understood the manufacturer's instructions, is
suitably trained, and is conversant with safety
and adjustment procedures to be adhered to
during operations. Operators are expressly
forbidden from using the machine under the
influence of alcohol or drugs capable of affecting
physical and mental capacity.
The following conditions are essential:
- The operator must be able to read and under-
stand all the information in this manual.
- Make sure you have a thorough knowledge
of the capabilities and characteristics of this
machine.
- Keep unauthorised persons well clear of the
area of operations.
- Make sure that the machine has been installed
in compliance with established legislation and
standards.
- Make sure that all machine operators are
suitable trained, that they are capable of
using the machine correctly and that they are
adequately supervised during their work.
- Never leave nuts, bolts, tools or other equi-
pment on the machine to avoid the risk that
they could become entrapped between moving
parts during work.
- Do not touch power lines or the inside of
electric motors or other electrical equipment
until the power has been disconnected and
locked out.
- Read this manual carefully and learn how to
use the machine correctly and safely.
- Always keep this user manual in a place where
it can be readily consulted when working with
- E - Operator's manual
nglIsh