Installation; Setting Up - Geemarc CLA9 Gebrauchsanleitung

INSTALLATION

Setting Up

Open the battery compartment. Insert the supplied rechargeable battery (2.4V )
into the battery compartment located on the rear of the CLA9/CLA9T
Communication Piece.
You have also the possibility to insert 2 singles batteries ( 1.5V AAA non
rechargeable ) instead of the one supplied .
Plug the battery charger into the mains supply and plug the other end of the
lead into the charging port on the left hand side of the CLA9/CLA9T
Communication Piece. Switch the mains supply on.
If the 'On' LED turns red when in use, the CLA9/CLA9T needs recharging, or
replace new batteries if standard AAA are installed . During charging the LED
turns on green , when fully charged , the LED is off.
Headset
Insert the headset lead into the headset port found on the base of the
Communication Piece.
6