Installation - Geemarc CLA40 VOX Handbuch

INSTALLATION

HOW TO SET THE BATTERY
The CLA40VOX amplifier needs with a 9V PP3 battery
(not provided). To insert the battery into the amplifier:
- Open the battery compartment located on the base by
pressing the small plastic lock.
- Insert the 9V battery with the correct polarity into the
connector in the battery compartment.
- Replace the battery cover.
- The amplifier is now ready to be connected to the
phone.
HOW TO CONNECT THE CAL40VOX TO THE PHONE
To connect your phone to the CLA40VOX amplifier:
- Unplug the handset from your telephone base socket.
- Connect the small lead supplied with the CLA40VOX to
the telephone base socket and to the input socket (1)
located at the top of your CLA40VOX .
- Connect your handset curly cord to the output socket (2)
located at the front of your CLA40VOX.
VOICE CONTROL : As soon as the CLA40VOX will
detect a voice, a sound from the earpiece or the
microphone, it will turnONautomatically (LED lit) then
during a silence more than 15secs it will also turn OFF
automatically.
IMPORTANT : The CLA40VOX cannot be used with
one-piece telephones which have a keypad on the
handset.
5