AKG WMS40 SO 40 Bedienungshinweise Seite 11

2 Description
2.1 Introduction
Dear Customer:
Thank you for purchasing an AKG
product. This Manual contains important
instructions for setting up and operating
your equipment. Please take a few
minutes to read the instructions below
carefully before operating the equip-
ment. Please keep the Manual for future
reference. Have fun and impress your
audience!
2.2 Unpacking
1 SO 40 1 AAA size
transmitter battery
Check that the package contains all the
parts listed above. If anything is missing,
please contact your AKG dealer.
2.3 Optional Accessories
2.4 Description
The SO 40 is a WMS 40 microtools
Series miniature transmitter specifically
designed for direct connection to a
microphone.
The transmitter features a 3-pin stan-
dard XLR connector that allows you to
connect the transmitter directly to a
dynamic microphone (e.g., AKG Emotion
Series) or a condenser microphone with
an internal power supply (e.g., AKG
1 black bat-
C 1000 S).
tery cover
The SO 40 operates on a single fixed,
CU 40 charger
quartz stabilized carrier frequency in the
710 MHz to 865 MHz UHF band and
uses a permanently attached flexible
antenna.
The color of the battery cover indicates
the carrier frequency of your transmitter.
You can replace the color code battery
cover with the supplied black replace-
ment cover.
2.5 Controls (Refer to fig. 1)
1 ON/MUTE/OFF: This slide switch
provides three positions:
ON: Power to the transmitter is on.
M: The signal delivered by the micro-
phone is muted while power and the
RF carrier frequency remain on. This
prevents the receiver from respond-
ing to interference from other trans-
mitters.
OFF: Power to the transmitter is off.
2 Battery compartment for one 1.5-V
AAA size battery (supplied).
9