Bikini Zone - Silvercrest SWWS 240 C2 Bedienungsanleitung

10) Grip the wax strip at the lower end and pull it off upwards with
a rapid movement against the direction of hair growth .
11) When you are finished with the treatment, pull the plug from
the mains power socket to turn off the appliance . The control
lamp 2 goes out .

Bikini zone

Once the wax beads 9 are completely melted:
1) Open the lid 7 by turning it anticlockwise slightly and lifting it
upwards .
2) Pick up a little wax using the flattened edge of the spatula 8 .
You can wipe off excess wax on the rim of the appliance .
3) After application, you can place the spatula 8 into the tray 6
on the edge of the appliance so that the spatula 8 projects over
the inner bowl 1 .
NOTE
► When epilating the bikini zone, treat only small areas at once .
The skin is very sensitive .
4) Tighten the skin with one hand and apply the wax in the
direction of hair growth (towards your inner thigh) .
5) Wait about 30 – 60 seconds until the wax is dry .
6) Grip the wax strip by the thicker end (the end nearer to your
inner thigh) and pull it off downwards with a rapid movement
against the direction of hair growth .
Repeat the process for the remaining areas of skin .
7) When you are finished with the treatment, pull the plug from
the mains power socket to turn off the appliance . The control
lamp 2 goes out .
■ 80 │ GB │ MT
SWWS 240 C2