Start-Up; Inserting The Back-Up Batteries; Inserting Batteries Into The Remote Control - Silvercrest KH 2306 Bedienungsanleitung

C Remote control
g MUTE
: Switch off sound
h VOL-/+
: Adjusting the volume.
DISPLAY
j
: Switch the display
k PROG/P-MODE
: Programming /playback function
l FOLDER-/-10,
FOLDER+/+10
: Select previous folder / reverse10
songs, select next folder / 10 songs
forward
y
: Previous/next song,
reverse/forward search
x PLAY/PAUSE
: Start/Suspend playback
c
Battery compartment
v STOP
: Stop playback
BAND
b
: Select frequency range
n CLOCK SET
: Setting the time
m RADIO
: Select radio mode
M AUX
: Select audio input
CD/MP3
N
: Select CD-/MP3 mode
B STANDBY
: Switch device on / into standby
V FM MODE
ST./MO.
: In radio mode stereo / mono
playback
D Loudspeaker (2)

Start-up

Unpacking the device
Remove all packing material. Remove also the
transport restraint from the CD tray.
Important!
Do not permit small children to play with the plastic
packaging. There is a risk of suffocation!
Check the items supplied
Whilst unpacking, check that all of the following
items are available to you:
- Micro System
- Remote Control
- 2 1.5 V Batteries, Type "AA/Mignon/R06"
- 2 Loudspeakers
Placement
• Place the Micro System and the loudspeakers on
a level and horizontal surface.
Place the speakers to the right and left of the Micro
System. Please ensure to run the speaker cables
without creating a tripping hazard.

Inserting the back-up batteries

The backup batteries will ensure a continuous time
display, even during a power failure
For this, you require three 1.5 V Micro AAA/R03
batteries (not included).
1. Open the cover of the battery compartment at
the underside of the Micro System.
2. Insert the batteries. Make sure the polarities are
correct.
3. Replace the battery compartment cover. A clicking
sound must be audible when latching in the cover.
Inserting batteries into the remote
control
In order to activate the remote control, please insert
both 1.5 V Mignon AA/R06.batteries (supplied)
1. Open the battery compartment on the rear of
the remote control.
2. Insert the batteries, ensuring their positioning
complies with the polarity markings shown in
the battery compartment.
3. Carefully close the battery compartment lid until
it clicks into place.
- 33 -